ServicesLight Demolition
Light Demolition in Rio Vista
We tear out the things that are not holding up your home: worn decks, leaning fences, old cabinets, dead hot tubs. Then we haul it all away. Before anything comes down, we explain what is involved and what it will cost.

What light demolition covers, and where it stops
Light demolition means dismantling non-structural parts of your home and yard. That includes a deck, a run of fence, kitchen cabinets, a bathroom vanity, carpet and pad, a spa or a backyard playset. We take it apart, load every piece and drive it off, so the space is ready for whatever comes next.
Here is the line we draw. We do not cut into load-bearing walls, roof framing or foundations, and we do not disconnect gas, electrical or water lines. If a wall carries weight or a fixture is still live, a contractor or the right tradesperson, such as an electrician or plumber, handles that part first. On the estimate visit we will tell you which side of that line your project falls on.
Around Rio Vista, much of this work is outdoors. Think of decks and fences that have taken years of sun and steady wind. Interior tear-outs are just as common before a remodel, when you want the old cabinets and flooring gone before the new crew shows up.

What we take apart and haul away
- 01
Decks and patio covers
We pull the deck boards, cut or unbolt the joists and beams, and remove the posts. Posts set in concrete footings either get dug out whole or broken off below grade. We will tell you which one your project needs and why.
- 02
Fences and gates
Wood pickets, rails, posts and gates, plus chain-link fabric, top rail and line posts. Expect the concrete around each post to be the slowest part of the job.
- 03
Kitchen and bath tear-outs
Once a plumber has capped the supply lines and disconnected the drain, we remove upper and lower cabinets, laminate or tile countertops, vanities, toilets and sinks.
- 04
Flooring and non-structural drywall
Carpet, pad and tack strip, floating laminate, and drywall from partitions that carry no load. Sheet vinyl and glued-down tile in older houses can hide asbestos, so those wait until a test clears them.
- 05
Hot tubs and playsets
After an electrician has disconnected the spa circuit, we cut the shell and frame into pieces that fit through a side gate. Wood and metal play structures come apart at the bolts.
- 06
Haul-off and sweep-up
Every piece leaves on our truck, and we sweep and run a magnet for nails. Our clean-space guarantee means that if we miss anything, we come back and get it at no charge.
Questions about Light Demolition?
Call(707) 940-8779Signs it is time to tear something out
Deck boards that give underfoot
Push a screwdriver into a board or joist end. If it sinks in easily, the wood is rotting. Rot usually starts where joists meet the ledger board against the house, and that is the part you cannot see.
A fence leaning at the posts
Wood posts rot right at the soil line, where they stay damp. Once a few go, propping up the panels only buys a little time.
A remodel on the calendar
Clearing out cabinets, flooring or an old deck before the contractor arrives keeps their schedule focused on building.
Swollen cabinets under the sink
Particleboard puffs up and crumbles after a slow leak. You cannot refinish it back to sound.
A spa that no longer runs
A dead heater or pump plus a waterlogged cover often costs more to fix than the tub is worth. Meanwhile it takes up the yard.
How a tear-out day runs
- 1
Free on-site estimate
We look at how the structure is built and attached, check access from the truck and ask about utilities. You get a firm number before we leave, and the price quoted on site is the price you pay. There are no hidden fees.
- 2
Prep on your side
Have any gas, power or water to the item shut off and capped by a qualified plumber, electrician or your gas utility. Get suspect older flooring or ceiling material tested. Clear a path and move vehicles out of the driveway.
- 3
Dismantling
We work from the top down. We lay down floor protection along the carry path and pull or bend nails as we go, so loaded pieces are safe to handle.
- 4
Sorting and hauling
Lumber, metal and concrete are kept separate on the truck. Clean metal goes to recycling, and treated lumber goes to a facility that accepts it.
- 5
Sweep and walk-through
We sweep, magnet the ground for fasteners and walk the area with you before we call it done.
What moves the price of light demolition
The estimate is free, and it is the number you pay. What sets that number is how much labor the teardown takes and how much material has to go to disposal. These are the main drivers.
- Size and material weight
- Volume matters, but so does weight. A tile countertop or a deck on concrete footings weighs far more than the same footprint of wood and drywall.
- How it is built and attached
- A deck lag-bolted to the house, or fence posts set in concrete, takes more time than nailed framing on blocks.
- Access to the truck
- A backyard reached through a narrow side gate, or a second-floor bathroom, means more carrying per load.
- Disposal by material
- Concrete, treated lumber and mixed debris each go to different places at different fees. Metal can sometimes offset a little of the cost.
Light demolition questions
Do I need a permit to tear out a deck or cabinets?
Small interior tear-outs often need no permit, but rules vary. Removing an attached deck or anything near utilities can require one. Your city or county building department makes that call, so check with them before work starts. On the estimate visit we will point out anything that looks like it may need a permit.
Can you take out a wall?
Only a non-structural partition, and only after the wiring and plumbing inside it have been dealt with. We do not remove load-bearing walls. If you are not sure which kind you have, an engineer or contractor should confirm it first.
What about asbestos or lead paint?
Houses built before about 1980 may have asbestos in popcorn ceilings, 9-inch floor tiles, sheet vinyl and tile mastic. Lead paint is common in homes from before 1978. Get suspect material tested by a lab first. We will not disturb it until the results clear it.
What coverage do you carry for this kind of work?
We are fully insured, with commercial general liability coverage. That matters when we are pulling ledger boards off the side of your house or carrying cabinet boxes through a finished hallway.
Can I keep some of the material?
Yes. Tell us at the estimate which pavers, lumber or hardware you want saved. We will stack it where you choose and haul the rest.
Find out what your tear-out really involves
We will come look, tell you what can come down safely and what needs a trade first, and give you a firm price on the spot. We serve Rio Vista and nearby towns including Oakley, Antioch and Brentwood.